Skip to main content
Version: 3.7.0

Liquify

Liquify gives you the freedom to control the proportions of multiple facial and body features.

properties

Add a Liquify Component​

Add a Liquify component by clicking + Add Component > Utility > Liquify in the Inspector panel.

Properties​

PropertyDescription
RadiusDetermines the radius of the liquify circle. Use the slider to set the radius to a value between 0 and 3. The default value is 1. See the demonstration below.
Intensity XDetermines the amount of vertical compression along the x-axis for the liquify circle. Use the slider to set the intensity to a value between -1 and 1. The default value is 0.5. See the demonstration below.
Intensity YDetermines the amount of horizontal compression along the x-axis for the liquify circle. Use the slider to set the intensity to a value between -1 and 1. The default value is 0.5. See the demonstration below.
Liquify AreaChoose what part of the liquify circle the effect is applied to. See the demonstration below.
  • Full (default) enables the Liquify effect on the entire circle.
  • Left, Right, Up, and Down enable the Liquify effect on the selected half of the circle.

Demonstrations​

Radius​

radius

Intensity X​

intensity x

Intensity Y​

intensity y

Liquify Area​

full   left   right
up   down